By default, the actual cycle time is shown as a red line and the target cycle time as a purple line in the assignment. Additional time lines can also be configured. It is also possible for the time lines to be predefined and fixed in the element configuration via the administration. You can choose between relative (value in %) or absolute (value in set time unit) as the calculation type. Both values refer to the cycle time. While a specific time is entered for an absolute value, the percentage of the target cycle time is entered for a relative value. The colors are freely selectable.

If any active time line is exceeded for a resource, a yellow exclamation mark is displayed on the resource in the tree and in the chart. A corresponding message appears in the tooltip.

Note: These changes apply to the entire element configuration, not just the open balancing

Settings: Time lines

By default, the EAWS evaluation is not recalculated with every change. Automatic recalculation can be activated using the "Calculate EAWS immediately" button.

Activated "Calculate EAWS immediately" button

"Display options" button

Display options: General