Readjustment while positioning
Definition: |
|---|
During realignment (after the actual joining process), additional corrective movements are performed to position the component in its final location. |
On the x-axis, the position of the element is defined by stops. On the y-axis there is no stop, so readjustment is necessary.
Example: |
|---|
After inserting a cable clamp into a bore hole, roughly align the cable. Exact alignment at a marking is being analyzed as a second positioning location. |
Readjustment / check
Definition: |
|---|
Readjustment / check refers to design-caused processes that must be performed prior to completing subsequent activities. |
Explanation:
Adjustment or check processes interrupt the assembly process and are considered waste.
Rule M-J1:
Definition: |
|---|
If, after completion of a joining operation (including any subsequent realignment), a one-time inspection (visual or manual) and/or adjustment is required due to design specifications, an Adjustment / Inspection operation shall be applied. |
Rule M-J2:
Definition: |
|---|
Disassembly or reassembly resulting from checking and adjusting a component has to be analyzed separately in ProKon. |